Motorola ET1 - Scan a Bar Code; Using the Camera

10
Scan a Bar Code
Depending upon configuration, bar code scanning can be
performed using the Scan Module, Scan/MSR Module or
rear-facing camera.
Using the Scanning Module
Use the Scanning or Scanning/MSR Module to scan bar codes.
Ensure that DataWedge is enabled and the cursor is in a text
field.
1. Point the top of the ET1 at the bar code.
2. Press the Left or Right Scan/Action button. The Decode LED
turns red indicating that a scan is in process.
3. The ET1 reads and decodes the bar code data. The Decode
LED turns green indicating a successful decode.
Using the Camera
Use the rear-facing camera to scan bar codes. Ensure that
DataWedge is enabled and the cursor is in a text field.
1. Point the back of the ET1 at the bar code.
2. Press the Left or Right Scan/Action button. The Decode LED
turns red indicating that a scan is in process.
3. On the screen, align the bar code in the viewing window.
4. The ET1 reads and decodes the bar code data. The Decode
LED turns green indicating a successful decode.
NOTE The ET1 offers additional data capture options. Refer to
the ET1 Enterprise Tablet User Guide for more
information.