Motorola GP140 - Deleting a Nuisance Channel; Adding a Deleted Nuisance Channel back to the Scan List; Scan Channel Discovery Alert; Scan List Member Priority

10
English
GP140 USER GUIDE
Deleting a Nuisance Channel
If a channel continually generates unwanted calls/
noise, you can temporarily remove it from the scan
list by performing a
Nuisance Channel Delete
operation.
NOTE: You cannot perform a Nuisance Channel Delete
on a priority channel or if there is only one remaining
channel in the scan list.
Adding a Deleted Nuisance Channel back to
the Scan List
Scan Channel Discovery Alert
Sometimes you need to know which channel the
radio has switched to during a scan operation. The
Scan Channel Discovery Alert gives you this
information.
After you have stopped a scan operation, this
feature gives you audio feedback when you select
the last channel that was switched to by the scan
operation. To do this:
Scan List Member Priority
A channel in your scan list may be prioritized (check
with your dealer for details). In such a case, the
radio will check that prioritized channel more
frequently than the other non-prioritized channels.
1. While the radio is on the Nuisance Channel,
press and hold the Scan key until you hear a
tone.
2. Release the Scan key.
1. Press the Scan key to stop the scan
operation.
2. Press the Scan key again to re-start the scan
operation.
1. Stop the scan operation.
2. Turn the Channel Selector to change the
channels.
3. When you reach the last channel the scan
operation switched to, the radio sounds an
alert tone.