Transceiver Performance Testing 4-5
***MDC
* See Table 4-4 of Basic Service Manual 68P80906Z54 for Test Frequencies.
Table 4-2. Transmitter Performance Checks
Test
Name
Service Monitor Radio Test Set Comments
Reference
Frequency
Mode: PWR MON
4th channel test frequency*
Monitor: Frequency error
Input at RF In/Out
TEST MODE,
Test Channel
4 carrier
squelch
PTT to continu-
ous (during the
performance
check)
Frequency error
±600 Hz UHF
Power RF As above As above As above Refer to Specifications
Voice
Modulation
Mode: PWR MON
4th channel test frequency*
atten to -70dB, input to RF
In/Out
Monitor: DVM, AC Volts
Set 1kHz Mod Out level for
0.025Vrms at test set,
80mVrms at AC/DC test set
jack
As above As above, meter
selector to mic
Deviation:
UHF:
≥ 4.0 KHz but ≤ 5.0
kHz (25 KHz Ch Sp)
Global.
4KHz (20 kHz Ch Sp)
U.S. and Canada.
Voice
Modulation
(internal)
Mode: PWR MON
4th channel test frequency*
atten to -70dB, input to RF
In/Out
TEST MODE,
Test Channel
4 carrier
squelch out-
put at
antenna
Remove modu-
lation input
Press PTT switch on
radio. Say “four” loudly
into the radio mic.
Measure deviation:
UHF:
≥ 4.0 kHz but ≤ 5.0
KHz (25 kHz Ch Sp)
High-Speed
Data Modu-
lation***
As above TEST MODE,
Test Channel
4 high speed
output at
antenna
PTT to continu-
ous (during the
performance
check)
Deviation:
UHF: ≥ 2.5 kHz but ≤
3.5 KHz (25 kHz Ch
Sp)
Low-Speed
Data Modu-
lation UHF
As above TEST MODE,
Test Channel
4 TLS output
at antenna
PTT to continu-
ous (during the
performance
check)
Deviation:
UHF: ≥500Hz but ≤
1000Hz (25 kHz Ch
Sp)
DTMF
Modulation
As above,
4th channel test frequency*
TEST MODE,
Test Channel
4 DTMF out-
put at
antenna
As above Deviation:
UHF: ≥ 3.05 kHz but ≤
3.45 kHz (25 kHz Ch
Sp)
PL/DPL
Modulation
As above
4th channel test frequency*
BW to narrow
TEST MODE,
Test Channel
4
TPL
DPL
As above Deviation:
UHF: ≥500Hz but ≤
1000Hz (25 kHz Ch
Sp)
To Next Page
Loading...
