100 Section 2E. Contacts
to the Contacts list or press P to return to standby
mode.
To create a Contacts entry:
1. Press M > Contacts > [New Contact].
– or –
Press M
> Contacts > M > New Contact.
2. If you want to assign a name to the entry:
䡲 Select Name. Enter the name. When you are
finished, press r.
3. If you want to assign a ring tone to the name:
䡲 Select Ringer. Select the ring tone you want to
assign.
4. To assign a Contacts type to the number or
address being stored:
䡲 Select the Contacts type field.
䡲 Select the Contacts type you want to assign.
(
Mobile, DC, Work1, Work2, Home, Email, Fax, Pager,
Talkgroup, Group, IP, or Other.)
5. To store a number or address:
䡲 Select the # field (or ID for an email address, or IP
for an IP address).
䡲 Enter the number or address. For phone
numbers, use the ten-digit format. For Direct
Connect numbers, be sure to include the
asterisks (*).
䡲 For email addresses, see “Entering Text” on
page 21.
䡲 When you are finished, press r.
6. If you want to assign more options to the number,
including
Speed # and Voice Name, select [Options]
and proceed to steps 7-9. Otherwise, skip to
step 10.
7. The default Speed Dial number assigned to a
phone number is displayed in the
Speed # field.
This is always the next available Speed Dial
location. If you want to assign the phone number
to a different Speed Dial location:
䡲 With the Speed # field highlighted, press r.
䡲 Press Delete (right softkey) to delete the current
Speed Dial number.
To Next Page
Loading...
