156 Section 3A. Service Features: The Basics
6.
If you want to receive a report confirming that your
message was delivered, select
Report > On Delivery.
7. If you want to set a date after which attempts to
deliver the message end:
䡲 Select Valid Until, select a date by scrolling or
entering numbers, and press r.
䡲 To set no date, press No Date (left softkey).
8. To send the message, press Send (left softkey).
– or –
If
Send is not one of your options, press M and
then select
Send.
Replying to a Message
You can reply to a received message while you are
viewing it. If you have already viewed a message, you
can also reply to it while it is highlighted in the
message center. You cannot reply to unread
messages.
When you reply to a message, some of the fields in
your reply are filled in automatically:
䢇 To — the phone number or email address of the
sender of the message you are replying to. If you are
sending a reply to all, some recipients may be in this
field.
䢇 Mesg — the first 40 characters of the message you
are replying to. Text you add to the body of your
message appears above this.
䢇 Subject — “Re:” followed by the subject line of the
message you are replying to, if any.
䢇 Cc — If you are sending a reply to all, some recipients
may be in this field.
To reply to a message:
1. View the message you want to reply to. If you have
already viewed the message, scroll to it.
2. To reply to the sender only, press Reply (left
softkey).
– or –
To reply to the sender and all recipients, press M
and select
Reply All.
To Next Page
Loading...
