Motorola MBP21 - Parent Unit Battery Installation

10
Getting Started
2.3 Parent unit battery installation
As an option, the Parent Unit can be powered by alkaline batteries
(Size AAA x 2, NOT included), so that it continues to work if you
disconnect it from the mains power to carry it to another location.
Please follow the steps below to install alkaline batteries.
• Open and lift the battery door up as shown in the figure. (Fig.b1)
(Fig.b1)
(Fig.b2)
(Fig.b3)
• Insert the alkaline batteries follow the direction into battery
compartment.(Fig.b2)
(Fig.b1)
(Fig.b2)
(Fig.b3)
• Insert the catches at the top of the battery door then close the
door as shown in the picture. (Fig.b3)
(Fig.b1)
(Fig.b2)
(Fig.b3)