12 Getting Started
4. If there is no connection or you are out of range, the video display will go
off, the symbol will flash on the LCD display, and the unit will beep
every 9 seconds. (If the unit is on scan the
1 ?
symbol displays.)
Move the Parent Unit closer to the Baby Unit to re-establish the link.
5. Press and hold the
P POWER ON/OFF button, until the progress bar
scrolls across fully, to turn OFF the Parent Unit.
NOTE
The battery icon will turn Red, flash, and beep approximately every 5
seconds to indicate that the battery is low and needs to be recharged. The
battery pack will take approximately 16 hours to charge.
When charging
1. If the Parent Unit is turned OFF, when the Adapter is plugged in, it displays
the "Power Adapter" icon briefly, then a large battery icon with internal
segments cycling for 60 seconds, before the display goes blank. Note, the
Unit will continue to charge. The Blue LED at the top left corner will light up
to indicate that the Adapter is plugged in.
2. If the Parent Unit is turned ON, when the Adapter is plugged in, the battery
icon in the screen’s top right corner will show that the battery is charging
by cycling the internal segments. The segments stop cycling when the
battery is fully charged. The Blue LED at the top left corner will light up to
indicate that the Adapter is plugged in.
To Next Page
Loading...
Need help?
General
