Related Products Motorola MBP36XL
The Stargrip screws to the bottom of several cameras and will connect to the Orbit but we don't
promote it. It is used to elevate and angle the camera if placed on a dresser or other flat
surface. It provides better stability because the legs can be spread apart to provide a wider
stance. You can also wrap the stargrip around a pole or other vertical support by bendingthe
legs to fit.
Noise interference on your parent unit.
Related Products Motorola MBP36XL
• Your Baby and Parent Units may be too close. Move them farther apart.
• Make sure there is at least 1 to 2 meters between the 2 units to avoid audio feedback.
• lf the baby unit is too far away it may be out of range, so move the Baby Unit closer to the
Parent Unit.
• Make sure the Baby and Parent Units are not near other electrical equipment, such as a
television, computer or cordless/mobile telephone.
• Use of other 2.4 GHz products, such as wireless networks (Wi-Fi® routers), Bluetooth™
systems, or microwave ovens, may cause interference with this product, so keep the baby
monitor away at least 1.5m (5ft) from these types of products, or turn them off if they appear
to be causing interference.
• If the signal is weak, try moving the Parent and/or Baby Unit to different positions in the
rooms.
If the baby unit has lost its link with the parent unit.
Related Products Motorola MBP36XL
• Try recharging or press the RESET button once on the Parent Unit. • If the Baby Unit is too far
away it may be going out of range, so move the Baby Unit closer to the Parent Unit.
• Reset the units by disconnecting the Baby Unit from electrical power and press the RESET
button once on the Parent Unit. Wait about 15 seconds before reconnecting. Allow up to one
minute for the Baby Unit and the Parent Unit to synchronize.
What should I do if I have no display on my screen?
Related Products Motorola MBP36XL
• Try recharging or press the RESET button once.
• Reset the units. Press the RESET button once on the Parent Unit and unplug both the units'
electrical power, then plug them back in.
• Is the unit turned on (green ON/OFF LED lit)?Press and hold the ON/OFF button on the Parent
Unit to turn it ON.
To Next Page
Loading...
Need help?
General
