Moto X Force/DROID Turbo 2
BASEBAND TROUBLESHOOTING GUIDES
MOTOROLA CONFIDENTIAL
If battery level reads 0%:
• Unplug factory cable, wait at least 3 seconds, then plug the cable back in.
• If this does not work, try plugging in a charger. If battery level is below 3V,
SOC LED will blink. The blinking will stop when battery is above 3V, at which
time soon after, phone will power into Charge Only Mode, and vibrate before
displaying a battery logo.
• If charge level is 1% or higher, leave on charger until 100%.
If battery level is too low, but 1% or higher:
• Plug in charge and leave until 100% full.
Debug Procedure: Battery Level
To Next Page
Loading...
