4-2 Control Head Programming: Software Version
Figure 4-2 Customer Programming Software Setup from Rear Accessory Connector
Figure 4-3 Customer Programming Software Setup with Test Box Connection
4.3 Software Version
Firmware version MOTOTRBO
TM
2.4 R02.40.00 or later MUST be programmed into the radio for
proper operation of the control head configuration. The control head must be attached to the radio to
perform firmware upgrade at the same time. This is to ensure that both the control head and radio
have the same software version.
DC
RF
ACC
Power
Supply
13.8 VDC
Rear Accessory
Connector
USB
Mobile & Repeater Rear
Programming Cable PMKN4010_
Radio
Front Connector
Handheld
DC
RF
ACC
Power
Supply
13.8 VDC
Rear Accessory
Connector
USB
No
Connection
Test Box RLN4460_
Radio
Mobile & Repeater Rear Accessory
Programming and Test Cable PMKN4016_
Front Connector
Handheld
To Next Page
Loading...