Disassembly/Reassembly Procedures: Disassembling and Reassembling the Control Head– General 5-5
5.5 Disassembling and Reassembling the Control Head– General
Since these Control Head may be disassembled and reassembled with the use of only ten screws
(board to housing), it is important to pay particular attention to the snaps and tabs, and how parts
align with each other.
The following tools are required for disassembling and assembling the Control Head:
• Small Flat Blade Screwdriver
• Control Head Dismantling Tool (Motorola Part No. 6686119B01)
• Torque Driver (2-36 lbs-in or 0.2-4.0 N-m), (Motorola Part No. RSX4043A)
• TORX™ T8 Driver Bit (Motorola Part No. 6680387A72)
• TORX Plus™ 6IP Driver Bit
• Phillips No.2 Screwdriver
• Plastic Tweezer
If a unit requires more complete testing or service than is customarily performed at the basic level,
please send Control Head to a Motorola Service Center listed in Appendix A.
The following disassembly procedures should be performed only if necessary.
To Next Page
Loading...