5-6 Disassembly/Reassembly Procedures: Disassembling and Reassembling the Control Head– General
5.5.1 Cable Disassembly from Transceiver Adapter
1. Unscrew the jack screws counter clockwise by using Phillips no.2 screwdriver and remove
the cable from transceiver adapter as shown in Figure 5-1.
Figure 5-1 Cable Removal
5.5.2 Transceiver Adapter Removal
1. Disengage the transceiver adapter from brick with a dismantle tool as shown in Figure 5-2.
Figure 5-2 Transceiver Adapter Removal
Jack Screws
Cable Transceiver adapter
Brick
Transceiver adapter
Dismantle tool
Brick
To Next Page
Loading...