5-10 Disassembly/Reassembly Procedures: Disassembling and Reassembling the Control Head– General
5.5.5 Handheld Back Housing Removal
1. Remove the five screws with T8 TORX™ driver to remove the control head main board as
shown in Figure 5-9.
Figure 5-9 Back Housing Screws Removal
2. Disconnect the hang-up board assembly wire from the main board by pulling it downwards as
shown in Figure 5-10.
Figure 5-10 Insulation Cap Assembly Removal
Screws
Back Housing
Control head
main board
Back Housing
Hang-up board
Assembly Wire
Main Board
To Next Page
Loading...