Disassembly/Reassembly Procedures: Disassembling and Reassembling the Control Head– General 5-13
4. Remove the three (3) screws with TORX Plus™ 6IP driver and remove the keypad and
display retainer from the front housing as shown in Figure 5-15.
Figure 5-15 Keypad and Retainer Removal
5. Remove the 26 pin connector latch by using the flat-blade screwdriver and release the color
display flex from keypad board. After that, remove the color display, then remove the PTT flex
from the 20 pin connector as seen in Figure 5-16.
Figure 5-16 Color Display Removal
Keypad and Display
Front Housing
Retainer
Screws
Front Housing
Color Display Flex
Color Display
26 Pin Connector
Keypad Board
PTT Flex
To Next Page
Loading...