5-16 Disassembly/Reassembly Procedures: Disassembling and Reassembling the Control Head– General
5.5.7 Handheld Front Housing Reassembly
1. Reassemble the PTT Paddle by inserting the bottom tab (thinner tab) to the bottom of the
catch. Then slightly bend the PTT paddle to insert the top tab (wider tab) into the top catch as
shown in Figure 5-20.
Figure 5-20 PTT Paddle Reassembly
2. Reassemble the keypad to front housing. Ensure that the sealing rib on the keypad is fully
inserted into the housing groove at keypad area as show in Figure 5-21.
Figure 5-21 Back Housing Reassembly
NOTE: Pinching of sealing rib is not allowed.
Thinner Tab
PTT Paddle
Wider Tab
Keypad
Front Housing
Sealing Rib
Housing Groove
To Next Page
Loading...