Radio
Controls
Steps
• The first line of the display
shows Radio Number: .
the second line of the
display shows a blinking
cursor. Use the keypad to
enter the subscriber alias
or ID and press
.
4
or to Radio Enable
and press to select.
The display shows Radio Enable: <Subscriber
Alias or ID> and the LED lights up solid green.
2 Wait for acknowledgement.
If successful,
If not successful,
Do not press during the Radio Enable
operation as you will not get an acknowledgement
message.
Lone Worker
This feature raises an emergency if there is no user
activity, such as any radio button press or activation
of the channel selector, for a predefined time.
Before raising the emergency, when the inactivity
timer expires, the radio warns the user via an audio
indicator.
If there is still no acknowledgement by the user
before the predefined reminder timer expires, the
radio initiates an Emergency Alarm.
Only one of the following Emergency Alarms can be
assigned to this feature:
• Emergency Alarm.
• Emergency Alarm with Call.
•
Emergency Alarm with Voice to Follow.
The radio remains in the emergency state allowing
voice messages to proceed until action is taken. See
Emergency Operation on page 57 on ways to exit
Emergency.
Note: This feature is limited to radios with this
function enabled. Check with your dealer or system
administrator for more information.
76
English
To Next Page
Loading...