Password Lock Features
If enabled, this feature only allows you access your
radio if the correct password is entered upon
powering up.
Accessing the Radio from Password
1 Power up your radio.
You hear a continuous tone.
2 Enter your current four-digit password. Press or to
edit each digit’s numeric value. Each digit changes
to
. Press to move to next digit. Press to
confirm your selection.
• Enter your current four-digit password with the
radio’s keypad. The second line of the display
shows . Press to proceed.
• Enter your current four-digit password. Press
or to edit each digit’s numeric
value. Each digit changes to . Press to move
to next digit. Press to confirm your
selection.
You hear a positive indicator tone for every digit
entered. Press to remove the last digit on the
display.
If the password is correct, your radio proceeds to
power up. See Powering Up the Radio on page
14.
If the password is incorrect, the display shows
Wrong Password. Repeat Steps 1 and 2.
After the third incorrect password, the display
shows Wrong Password and then, shows Radio
Locked. A tone sounds and the LED double blinks
yellow.
Your radio enters into locked state for 15 minutes,
and responds to inputs from On/Off/Volume
Control Knob only.
Note: The radio is unable to receive any call,
including emergency calls, in locked state.
Unlocking the Radio from Locked State
1 If your radio was powered down after being in the
locked state, power up the radio.
A tone sounds and the LED double blinks yellow.
The display shows Radio Locked.
77
English
To Next Page
Loading...