Preparing Your Radio for Use
English
5
Powering Up the Radio
Rotate the On/Off/Volume
Control Knob clockwise
until you hear a click. The
LED lights up solid green.
A brief tone sounds,
indicating that the power up
test is successful.
NOTE: There is no power
up tone if the radio
tones/alerts
function is disabled
(see Turning
Radio Tones/Alerts On or Off on page 38).
If your radio does not power up, check your battery. Make sure
that it is charged and properly attached. If your radio still does
not power up, contact your dealer.
To turn off the radio, rotate this knob counterclockwise until you
hear a click.
Adjusting the Volume
To increase the volume,
turn the On/Off/Volume
Control Knob clockwise.
To decrease the volume,
turn this knob
counterclockwise.
NOTE: Your radio can be
programmed to
have a minimum
volume offset
where the volume
level cannot be turned past the programmed minimum
volume. Check with your dealer or system
administrator for more information.
On/Off/Volume
Control Knob
LED
On/Off/Volume
Control Knob
To Next Page
Loading...