3
2. Connect and charge
Baby (camera) unit
1. Plug the DC plug of the power adapter into the power socket on the rear of
the baby (camera) unit and plug the other end of the AC adapter into the
wall socket.
2. The baby unit turns on and the power indicator lights up in blue first and
blinks in red if the parent unit has not been powered up or loss
connection with the baby (camera) unit.
WARNING
Strangulation Hazard. Children have STRANGLED in cords. Keep this cord out
of the reach of children (more than 1 meter or 3 feet away). Do not remove the
tags from the AC Adapters. Only use the AC Adapters provided.
Parent unit
A rechargeable battery is already pre-installed inside the parent unit. When
fully charged, you can move the parent unit without losing the link and picture
from the baby (camera) unit. When charging the battery for the first time,
charge for at least 16 hours continuously.
1. Plug the DC plug of the power adapter into the power socket on the side
of the parent unit and plug the other end of the AC adapter into the wall
socket.
2. Switch on the AC power and the parent unit will turn on.
3. When the parent unit is fully charged,
will appear steadily on the
screen display.
4. Press and hold the power button on the top of the parent unit to turn it on
and o.
Press and hold
To Next Page
Loading...
Need help?
General
