7
5.
Help
No display
• Try recharging the battery pack.
• Reset the parent and baby (camera) units. Unplug both units from the wall
socket, then plug them back in.
• Check if the parent/baby (camera) unit is powered on.
• When operated by the battery only, the parent unit display will go blank
after 5 minutes, 30 minutes or 60 minutes to save power (depending on
video settings).
The baby (camera) unit has lost its link with the parent unit
• The baby (camera) unit is too far away and may be out of range. Move the
it closer to the parent unit.
• Disconnect both the parent and baby (camera) units from the power outlet.
Wait for about 15 seconds and reconnect them. Allow up to one minute for
the parent and baby (camera) units to synchronize.
Noise interference on your parent unit
• Make sure there is at least 3 to 6 feet between the parent and baby
(camera) units to avoid audio feedback.
• The baby (camera) unit is too far away and may be out of range. Move the
it closer to the parent unit.
• Make sure the parent and baby (camera) units are not placed near other
electrical equipment, such as a television, computer or cordless/mobile
telephone. Move the parent and baby (camera) units 5 feet away from
other electrical equipment.
• Use of other 2.4 GHz products, such as wireless networks (Wi- Fi® routers),
Bluetooth™ systems, or microwave ovens, may cause interference with this
product.
• If the signal is weak, try moving the parent and/or baby (camera) units to
dierent positions in rooms.
For a full explanation of all features, download the user guide from
motorolanursery.com.
To Next Page
Loading...
Need help?
General
