PROGRAMMING
FEATURES
English
48
PROGRAMMING MICROPHONE
ACCESSORY GAIN LEVEL
To configure the Accessory Microphone Gain
Level, enter ’Programming Mode’ and scroll
through the programming options by short
pressing the PTT button.
The current accessory microphone gain level
setting will be blinking. You can select the
desired gain level (1=Low gain,2= Medium gain
or 3= High gain) by pressing the /
buttons.
Once you have selected the gain level you
want to program, long press the PTT button to
exit and save or short press the PTT button to
move to the next programming feature without
saving.
Note: The values available for accessory
microphone gain level are dependent upon
maximum levels the radio supports.
OTHER PROGRAMMING FEATURES
Scan
Scan allows you to monitor other channels to
detect conversations.
When the radio detects a transmission, it will
stop scanning and stays on the active channel.
This allows you to listen and talk to the people
on that channel without having to change the
Channel Knob. If there is talking going on
Channel 2 during this time, the radio will stay
on Channel 1 and you will not hear Channel 2.
After talking has stopped in Channel 1, the
radio will wait for 5 seconds before resuming
Scan again.
• To start scanning, press the SB2 button (*).
When the radio detects channel activity, it will
stop on that channel until activity on the
channel ends. You can talk to the person(s)
MIC
To Next Page
Loading...
Need help?
General
