PROGRAMMING
FEATURES
English
56
CLONING RADIOS
You can clone RDX™ Series radio profiles from
one radio (the ‘Source’ radio) to a second radio
(the ‘Target’ radio) by using any one of these 3
methods:
• One Multi Unit Charger (optional accessory)
• Two Single Unit Chargers and a Radio-to-
Radio cloning cable (optional accessory)
• the CPS (free software download)
Cloning with a Multi-Unit Charger (MUC)
The MUC is capable of cloning radios. To do
so, there must be at least two radios,
• a Source radio (radio which profiles will be
cloned or copied from) and
• a Target radio (the radio which profile will be
cloned from the source radio).
The Source radio has to be in Pocket 1, 3 or 5
while the Source radio to be cloned has to be in
Pockets 2, 4 or 6, matching in the MUCs
pockets by pairs as follows: 1 and 2 or 3 and 4
or 5 and 6 (*).
When cloning, the MUC does not need to be
plugged into a power source, but ALL radios
require charged batteries.
1. Turn ON the Target radio and place it into one of
the MUC Target Pockets
2. Power the Source radio following the sequence
below:
• Long press the PTT button and SB2
simultaneously while turning the radio ON.
• Wait for 3 seconds before releasing the
buttons until a distinctive audible tone is
heard.
To Next Page
Loading...
Need help?
General
