9
English
Charging Inside the Vehicle
1. Plug the vehicular charger adapter into the
vehicle’s auxiliary power outlet.
Note: Some vehicles’ auxiliary power outlets do not
maintain an electrical current once the vehicle has
been turned off. Rated input: 12 – 24 DC 1.2 A.
Charging the Battery
1. Insert a battery or radio with a battery into the
charger pocket, making sure the charging
contacts make contact with the battery. The
battery charging indicator LED on the
charger indicates:
Table 2. Battery Charging Indicators
Status LED Status Descriptions
Power On Green for
approximately
1 second
Successful charger
power-up
Charging Steady Red Battery in rapid charge mode
90%
Charged
Blinking Green Battery is charged to 90% or
greater capacity
Fully
Charged
Steady Green Battery is nearly charged or
fully charged
Fault Blinking Red Remove and re-insert radio
or battery
Standby Blinking
Amber
Battery is waiting to rapid
charge. Battery may be too
hot, too cold, or low voltage
68012003023.book Page 9 Monday, December 10, 2018 3:11 PM
To Next Page
Loading...
