Procedure:
To set the radio to Advanced Configuration mode, press and hold the PTT and SB1 buttons while turning
on the radio.
Result: Your radio shows the following indications:
● The green LED blinks.
● The Voice Announcement sounds.
NOTE:
● The Idle Programming mode is where the radio waits for you to start the radio programming cycle.
● When your radio is in the Idle Programming mode, press the PTT button to navigate through the
programmable features and hear the Frequencies, Codes, Auto-Scan and Active Channels.
5.1.2
Selecting Channel
RM Series radios have 89 frequencies for UHF in USA and 2 frequencies for Canada. In Idle Programming
mode, the channel number becomes the first adjustable value.
Prerequisites: Enter the Advanced Configuration Mode.
Procedure:
To select the required channel, press the SB1 or SB2 buttons.
Result: The Voice Announcement sounds the selected channel.
Postrequisites:
● To continue programming, press the PTT button.
● To save settings and enter the Idle Programming mode, press and hold the PTT button.
● To exit Advanced Configuration mode or turn off the radio, press and hold the PTT button twice.
5.1.3
Selecting the Interference Eliminator Code
RM Series radios have up to 219 codes available.
Prerequisites: Enter the Advanced Configuration Mode.
Procedure:
1. To cycle through the features, press the PTT button.
The Voice Announcement indicates “Code Number”.
2. To select the required code, press the SB1 or SB2 buttons.
The Voice Announcement sounds the code.
Postrequisites:
● To continue programming, press the PTT button.
● To save settings and enter the Idle Programming mode, press and hold the PTT button.
● To exit Idle Programming mode, press and hold the PTT button twice.
● To exit the programming mode without saving, turn off the radio.
68012009071-BD
Chapter 5: Radio Programming through CPS
25
To Next Page
Loading...
Need help?
General
