Motorola T2 User Manual

16 Using the phone
3. Using the phone
NOTE
The handset will automatically time the duration of all external calls. The call timer will
display after the rst 10 seconds of the call. When the call ends, the total duration of the
talk time stays on the display for 3 seconds.
3.1 Switch the handset on / o
Press and hold n to switch the handset on or o.
3.2 Calls
3.2.1 Make a call
1. Press h.
2. When you hear the dial tone, dial the number.
3.2.2 Preparatory dialling
1. Dial the number rst. If you make a mistake press
p to delete the last digit.
2. Press h to dial.
3.2.3 End a call
Press n, or place the handset back on the base or charger.
3.2.4 Receive a call
When you receive an external call, the phone rings and
icon flashes on the display.
1. If the handset is o the base then press h to answer the call, or if the handset is on the
base simply lift the handset to answer the call.
NOTE
If you prefer to press h when you lift up the handset to answer a call, you will need to
switch Auto answer o.
3.3 Adjust the earpiece volume
During a call, press u or
d
to increase or decrease the volume. There are 5 levels to
choose from.
3.4 Mute
You can mute your handset so that you can talk to someone nearby without your caller
hearing.
1. During a call, press
m. The display shows MUTE ON and your caller cannot hear you.
2. Press
m again to resume your call.
3.5 Intercom
3.5.1 Make an internal call
If you have more than one handset registered to the base, you can make internal calls
between two handsets.

Motorola T2 Specifications

General

Brand	Motorola
Model	T2
Category	Cordless Telephone
Language	English