Motorola T81 HUNTER - Set Direct Call; Features on Your Radio; Channel Scan Mode; Dual Watch Mode

English
8
5. MENU/GRP to exit.
Set Direct Call
1. Press MENU/GRP to enter Group Mode.
2. Press to enter All/Direct Call Setting.
3. Press or to select an ID Number.
4. Press or SEL/ to transmit Direct Call Command.
The selected Call Tone sounds. The display shows TX
icon and CALL icon while transmitting.
5. Press MENU/GRP to go back to All/Direct Call setting.
Features on Your Radio
Channel Scan Mode
Enables your radio to scan for active channels. When activity is
detected, your radio lands (stays) on that channel for 2 seconds
(5 seconds for VOX ON without headset). To transmit on that
channel, press the PTT button. When activity on the landed
channel ends, your radio continues scanning to other channels.
To turn the channel scan ON:
1. Press MENU/GRP to enter Common Menu. Advance to
”SCAN”.
2. Press SEL/ to turn ON channel scan.
3. Press MENU/GRP or PTT to turn OFF Scan mode.
Dual Watch Mode
Enables your radio to scan the current channel and another
channel alternately.
To set another channel and start Dual Watch:
1. Press MENU/GRP to enter Common Menu. Advance to
“2CH”.
2. Press or to select the channel, then press SEL/ .
3. Press or to select the Sub-code, then press SEL/ .
4. The radio starts to Dual Watch.
Note: If you set the same channel and Sub-code as the
current channel, Dual Watch doesn’t work.
5. Press MENU/GRP to turn the Dual Watch mode OFF.
Room Monitor
Enables your radio to detect voice/noises (according to the
sensitivity level set) and transmit back to the listening radio
without pushing the PTT button. The monitoring radio is not
able to receive any transmissions in this mode.
To turn Room Monitor ON:
1. Press MENU/GRP to enter Common Menu. Advance to
“ROOM”.
2. Press SEL/ to select.
3. Press or to the desired room monitor sensitivity level.
Note: Use level 1 in quiet environments. Use level 5 in very
noisy environments.
4. Press SEL/ to turn ON room monitor.
Press MENU/GRP to turn OFF Room Monitor.
Note: When the voice/noise in the monitored room
continues for more than 60 seconds, the monitoring
radio stop monitoring for 5 seconds, and resumes.
Silent Mode
Silent mode mutes all incoming calls. The backlight of the radio
blinks when there’s an incoming call. If the call is not answered,
the backlight turns off and the blinks until there is no signal.
The T80/T80 Extreme radio will vibrate when there is a missed
call.
The ID Number for Direct Call
The ID Name
68015000918.book Page 8 Thursday, January 12, 2017 2:47 PM