Motorola T81 HUNTER - Set Group Code; Set Ring Tone; Set ID; Set ID Name

7
English
Set Group Code
1. Press or to choose the Group Code.
2. Press SEL/ to complete Group Code setting.
3. The radio enters “Ring Tone Setting Menu”
4. Press MENU/GRP to go back to Group Menu.
Set Ring Tone
The user selects Ring Tone for a Direct Call. Ring Tones are the
same as Call Tones.
1. Press or to select a Ring Tone.
2. The selected Ring Tone sounds.
Set ID
Each radio in the group needs to be set with an ID. The user
can set an ID name of up to four (4) characters.
1. Press or to select an ID number.
2. If the ID is already taken, USED is seen. If USED is not
shown, then the ID is available.
3. Press SEL/ to advance to setting ID Name.
Set ID Name
The ID Name appears on the other radio’s display when you
make an All Call or a Direct Call. The ID Name also appears on
the other radio’s display when they are placing a Direct Call.
When no ID name is set, the unit number appears.
1. Press or to select a character that blinks on the
display.
2. Press SEL/ to select and move to the next character.
3. Press SEL/ to register the ID number and ID Name.
Note: The radio cancels selected ID Number and entered ID
Name, then exits from Group Menu when MENU/GRP
button is pressed.
Channel Setting in Group Mode
To set Auto Channel Change in Group Mode:
1. Press MENU/GRP to enter Group Mode.
2. Press SEL/ to enter Channel Setting.
3. Press or to “Auto Channel Change Setting”.
4. Press SEL/ to select.
A channel number blinks and “ALL” is seen.
5. Press or to select the channel.
6. Press SEL/ or to transmit Auto Channel Change
command.
7. Press MENU/GRP to return to Channel Setting in Group
Mode.
To set Manual Channel in Group Mode:
1. Press MENU/GRP to enter Group Mode.
2. Press SEL/ to enter Channel Setting.
3. Press or to “Manual Channel Setting”.
4. Press SEL/ to select.
A channel number blinks and “MY” is seen.
5. Press or to select the channel manually.
6. Press SEL/ to exit from Manual Channel setting.
7. Press MENU/GRP to return to Channel Setting in Group
Mode.
Set All Call
1. Press MENU/GRP to enter Group Mode.
2. Press to enter All/ Direct Call Setting.
3. Press or to select All Call Transmission. “SYNC” is
seen.
4. Press SEL/ or to exit this setting and transmit All Call.
All Call Tone sounds. and blinks while transmitting.
68015000918.book Page 7 Thursday, January 12, 2017 2:47 PM