Motorola TWO WAY RADIO User Manual

11
ALERTS
Channel Busy Indicator
The red LED will flash twice per second to indicate that the
channel is in use.
Call Tone
Press ^ to transmit your call tone, alerting users on the
same channel and code that you are about to talk. Your radio
has 5 call tones to choose from. Setting the call tone to 0
disables ^.
To Set the Call Tone
• With the radio on, press \ until E appears in the display.
• Current call tone setting 0-5 will begin to flash.
• Press ] or [ to change and hear call tones while the
setting number is flashing.
• Press M to set new call tone.
Roger Beep (Talk Confirmation Tone)
When you turn on this feature, your two-way radio transmits a
unique tone when you finish transmitting. It’s like saying
'Roger' or 'Over', and lets others know you’ve finished talking.
• To enable or disable the roger beep, press and hold ] as
you turn your radio on.
• When the roger beep is enabled ! will show in the display.
• When you release the M button you will hear the roger beep.
ACCESSORIES
Belt Clip
Your radio comes with a swivel belt clip.
• To attach, align belt clip post with hole in
the radio back and gently push until it
clicks into place.
• To remove, push release tab on top of
belt clip down to release catch and pull
belt clip from the radio back.
Front Covers
Your radio has a removable front cover
that allows you to customize your radio.
Note: Do not operate your radio without the cover.
To Remove
• With a 1/8 inch flathead screwdriver, push down in between
the top of the front cover and the radio.
• Gently pry the cover away from the radio.
• Pull the top of the removable cover away from the radio.
To Attach
• Reinsert housing tabs at the bottom of the removable cover.
• Press down to snap cover into place.

Motorola TWO WAY RADIO Specifications

General

Brand	Motorola
Model	TWO WAY RADIO
Category	Two-Way Radio
Language	English