20
The alarm symbol shows the current alarm status. cis displayed if the
alarm is turned on, e is displayed if the alarm is turned off.
➍ Press I to move the cursor to the alarm symbol.
➎ Press F or G until c is displayed.
➏ Press I to move the cursor to the hour digits.
➐ Press F or G to adjust the hour digits.
➑ Repeat steps 6 and 7 to adjust the minutes, AM/PM/24 hr., and date.
➒ Press K to activate your selection. The Q symbol is displayed on the
Standby screen.
Note:
To exit from any screen without making changes, press J.
PAGER ALARM
1035B30Book.fm Page 20 Monday, September 13, 1999 11:18 AM
To Next Page
Loading...
