Troubleshooting
VAP2400 Wireless Video Bridge • Installation Manual 16
Rapidly blinking WPS LED If the LED remains in this state for longer than two minutes, go to the unit’s back panel
and push the WPS button. The LED may continue flashing in a different pattern, rapidly
blinking for 1 second and then resting briefly before blinking again. If this occurs, wait
one to two minutes and then press the WPS button again.
Cannot configure a VAP unit as an
Access Point
If you cannot establish one of your units as an Access Point, it may indicate that your
router is not connected to your service provider’s network. (The operational mode LED
lights green on VAP units dedicated as Access Points and amber on VAP units dedicated
as Clients; see pp. 9–11 for more details.) If you experience this problem, contact your
service provider for assistance.
To Next Page
Loading...
