Need help?Do you have a question about the Motorola PTP 54500 and is the answer not in the manual?
General| Data Rate | Up to 300 Mbps |
|---|---|
| Encryption | 128-bit AES |
| Product Type | Wireless Bridge |
| Modulation | OFDM |
| Security | AES Encryption |
| Frequency Band | 5 GHz |
| Interface | Ethernet |
| Operating Temperature | -40°C to +60°C |
Safety guidelines regarding RF exposure and minimum separation distances.
Details calculations for safe separation distances and power compliance.
Provides critical safety warnings for installation and operation procedures.
Details the components and functionality of the PTP 500 Series Bridge.
Explains using the web server for system configuration and management.
Discusses frequency variants and spectrum management approaches.
Explains the use of Region Codes and License Keys for product operation.
Details operational restrictions including Radar Avoidance.
Provides guidelines for selecting installation locations for ODUs and PIDU Plus.
Lists essential preparation steps before commencing installation.
Outlines the sequence of steps for installing the PTP 500 Series.
Emphasizes proper grounding for ODU to protect against power surges.
Describes aligning ODUs for best signal strength using audible tones.
Provides a detailed view of system operation from wireless and network perspectives.
Accesses password-protected system administration features.
Organizes configuration into general, LAN, QoS, and Save/Restore sections.
Configures the unit's LAN interface, including IP address and subnet mask.
Allows backup and restoration of unit configuration files.
Displays key statistics for the Ethernet Bridge and wireless performance.
Displays detailed statistics for Ethernet and wireless interfaces.
Describes installation pages and their use during configuration.
Guides on entering IP configuration details within the installation wizard.
Details parameters for wireless configuration within the installation wizard.
Details variances in operation when Radar Avoidance or RTTT are enabled.
Configures remote management settings like Telnet, SNMP, and SMTP.
Provides a graphical tool for viewing diagnostic data like Vector Error.
Allows downloading snapshots of system diagnostics in CSV format.
Allows changing the system administration password.
Page for updating the 500 Series bridge license key.
Allows reloading a software image to recover from corruption.
Resets IP and Ethernet settings to factory defaults.
Reboots the unit and confirms the action.
Guides troubleshooting hardware-related issues.
Guides troubleshooting radio link issues.
Guides on testing the system wiring after installation.
Covers generic installation instructions for connectorized versions.
Provides a step-by-step guide to enabling AES link encryption.
Explains how to enable AES link encryption via configuration or wizard.
To Next Page
