8 Web Page Reference 
 
91
8.3.1.3  LAN Configuration Page – Use VLAN For Management Interfaces 
The layout of the LAN Configuration page changes if this attribute is enabled in order to allow 
the VLAN VID and VLAN Priority to be set, see Figure 34. The VLAN settings are applied only 
after the unit is rebooted. 
CAUTION:  You must ensure that you can access the VLAN which you configure here, 
otherwise you will be unable to access the unit following the next reboot. 
CAUTION: The PTP 500 management function is only compatible with single VLAN tagged 
packets. Any management packet with two or more packets will be ignored. 
 
Figure 34 - VLAN Configuration Fields