QUICKSTART GUIDE | VB400 10
USING YOUR VB400
The VB400 series of cameras are intuitive and simple to use.
TO START / STOP RECORDING (CONFIGURABLE)
Users can activate recording by pressing on the single front button located in the centre of the badge as shown.
Recording is stopped by pressing and holding the front button.
Record activation and deactivation buttons are
configurable by Administrators.
Start Recording initiated will be indicated by a short
bleep, the two upper LEDs showing red.
Press centre button to
start/stop recording
Solid red LED
To Next Page
Loading...
Need help?
General
