MOTU 8pre - CONTROLLING CUEMIX DSP (CONTINUED); CUE MIX DSP CONTROL IN DIGITAL PERFORMER;AUDIODESK

REDUCING MONITORING LATENCY
50
Follow the directions below in the section that
applies to you.
Controlling CueMix DSP from within AudioDesk
or Digital Performer
To turn on CueMix DSP in AudioDesk and Digital
Performer:
1 From the Setup menu, choose Configure Audio
System>Input Monitoring Mode.
2 Choose the Direct hardware playthrough option,
as shown below in Figure 10-7.
3 From the Studio menu, choose Audio Monitor,
and enable Audio Patch Thru (the button with the
headphone icon on it).
Figure 10-7: Enabling CueMix DSP in AudioDesk or Digital Performer.
Note: the ‘Only during recording...’ and ‘Always’ options are for
AudioDesk 2 and DP4 only. DP5 has expanded input monitoring
features. Consult your DP5 documentation.
Once enabled, CueMix DSP monitoring is tied
with Digital Performer or AudioDesk’s Audio Patch
Thru feature: when you record-enable a track, the
track’s input is routed directly to its output (via
CueMix DSP in the 8pre hardware). For example, if
you record-enable a track called guitar in your DP
or AudioDesk project, and its audio input
assignment is Analog in 2, and its audio output
assignment is channels 7-8, CueMix DSP no-
latency hardware monitoring will automatically be
set up from analog in 2 to outputs 7-8.
Controlling CueMix DSP from within other
software
Consult the manual for your software.
!8pre Manual/Mac Page 50 Tuesday, October 12, 2010 5:52 PM