MOTU SMPTE SETUP
63
RESOLVING DP OR AUDIODESK TO SMPTE
TIME CODE
To resolve your Digital Performer/8pre system
directly to SMPTE time code with no additional
synchronization devices, use the setup shown
below in Figure 12-3. Choose Receive Sync from the
Setup menu and choose the Sample accurate
option. Then make sure that the Slave to External
Sync command in the Studio menu is checked.
Make sure the Clock Source setting in the MOTU
Audio Setup window is set to SMPTE. Also, make
sure that you’ve connected an LTC input signal to
an 8pre analog input, and that you’ve specified that
input in the SMPTE Setup.
RESOLVING CUBASE OR NUENDO TO
SMPTE TIME CODE
To resolve your 8pre directly to SMPTE time code
with no additional synchronization devices, use
the setup shown in Figure 12-3. Make sure the
Clock Source setting in the MOTU Audio Setup
window is set to SMPTE. Also, make sure that
you’ve connected an LTC input signal to an 8pre
analog input, and that you’ve specified that input in
the SMPTE Setup.
!8pre Manual/Mac Page 63 Tuesday, October 12, 2010 5:52 PM
To Next Page
Loading...
