Moultrie Feeder Feet Gen2 User Manual

Instructions for Feeder Feet Gen2
THANK YOU for your purchase of the Feeder Feet Gen2. Please read this sheet before
operating the unit. If you should have any questions about this product or any other
Moultrie product, please contact us using the information on the back of this sheet.
To help us to better serve you and to activate your Lifetime Warranty, please submit
your warranty information online at http://www.moultriefeeders.com/warranty
INSTALLING ON 1.5” SQUARE TUBE LEGS
A
Remove pin from feeder feet assembly. Slide whole assembly into 1.5” Square tube feeder leg.
Insert pin through hole of leg and adapter. Insert Stake through foot into the ground to the desired depth.
Repeat for all three feeder feet.
WARNING: Do not use feeder feet on hard/slick ground or surfaces without stakes.
MOULTRIE_Feeder Feet Gen2 Manual-ENGLISH_8-13-20.indd 1MOULTRIE_Feeder Feet Gen2 Manual-ENGLISH_8-13-20.indd 1 8/17/20 8:32 AM8/17/20 8:32 AM

Moultrie Feeder Feet Gen2 Specifications

General

Product Type	Feeder Feet
Model	Gen2
Material	Steel
Color	Black
Quantity	4
Compatibility	Moultrie Feeders

Summary

Installing Feeder Feet on 1.5-inch Square Tube Legs

Step 1: Remove Pin from Feeder Feet Assembly

Detach the retaining pin from the feeder foot assembly before installation.

Step 2: Attach Assembly to 1.5-inch Square Tube Leg

Slide the feeder foot assembly into the 1.5-inch square tube leg for secure fitting.

Step 3: Secure Pin Through Leg and Adapter

Insert the retaining pin through the designated holes of the leg and adapter.

Step 4: Insert Stake into Ground

Place the stake through the feeder foot and push into the ground to the required depth.

Step 5: Repeat for Remaining Feeder Feet

Perform the installation steps for all three feeder feet for complete setup.

Installing Feeder Feet on 1.25-inch Legs

Step 1: Remove Pin from Feeder Feet Assembly

Detach the retaining pin from the feeder foot assembly before installation.

Step 2: Remove Adapter from Feeder Feet Assembly

Press the button to release and remove the adapter from the feeder feet assembly.

Step 3: Insert Foot into Leg and Secure

Press button and insert foot into square or round leg until it snaps into place.

Step 4: Insert Stake into Ground

Place the stake through the feeder foot and push into the ground to the required depth.

Step 5: Repeat for Remaining Feeder Feet

Perform the installation steps for all three feeder feet for complete setup.