12
20. Glue the 1/8” Lt Ply cowling mount parts into the front former as shown below.
21. Place some tape behind the second former to protect the fuselage sides. Sand the top front of
the fuselage sides to follow the curve of the front 2 formers. Line up the 1/16” top front balsa
sheet, so there is the same amount of material hanging off on each side. Lift up one side and
tack down with thick CA. Then glue the other side with thick CA as well. Sand the sides of the
front top sheet to be flush with the fuselage sides.
To Next Page
Loading...
