EasyManuals Logo

Mountfield HP42H User Manual

Mountfield HP42H
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
10
LONG TERM - (if you are not using your mower for more than 28 days)
Give the machine a thorough clean, paying particular attention to the underside
Lubricate all moving parts
Empty the fuel tank either by running the mower out of fuel or tip the machine backwards and onto the back right wheel to
drain the fuel into a suitable container. To drain the carburettor it is necessary to slacken the drain screw. The drain screw
is situated under the carburettor on the oat bowl (see diagram 4 in the engine manual). A bolt holds the bowl in place on
the very bottom, but on an angle slighlty closer to you is another bolt with a red washer. This is the drain screw.
FAULT FINDING
PROBLEM SOLUTION
Engine will not start
Check there is ample clean, fresh fuel in the tank. Any stale fuel needs to be drained
from the machine.
Check the cutter blade is not fouling the ground preventing free rotation.
Engine will not stop
Check the Operator Presence Control (OPC) lever is fully released.
Remove spark plug lead to stop the engine using insulated gloves and refer to dealer.
Engine smokes Engine may be overlled with oil or may have been tipped.
Engine running unevenly
Check the petrol ller cap isn’t too tight - it should only be nger tight. If fuel is over 28
days old it has gone stale and will need replacing.
Failure to cut grass
properly
Stop the engine and disconnect the spark plug lead using heat resistant gloves.
Check blade attachment bolt is tight.
Check condition of blade.If seriously worn or damaged replace with a new one.
Failure to collect grass
properly
Stop the engine and disconnect the spark plug lead using heat resistant gloves
Check and make sure there is no build up of grass inside the casing.
Check grass collector is allowing air to ow through the fabric. If it is clogged
it should be washed carefully.
If the grass collector is not clogged raise the height of cut to increase airow.
Check to ensure the engine is running at the correct speed (approximately from
2,800rpm to 3,000rpm)
If conditions are too severe to use the grass collector, remove it and work with the
deector in position
Machine vibrates
excessively
This will certainly indicate that the blade has become badly damaged. Stop the engine,
disconnect the spark plug lead and examine the blade assembly. Refer to your local dealer.
HELPLINE
0800 121 6585
or visit
www.servicelink.org.uk
This product is supported by Service
Link. If you have been unable to find the
information you require above please
call the Service Link helpline. Here you
will find 1-2-1 help and advice from
garden machinery repair specialists.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mountfield HP42H and is the answer not in the manual?

Mountfield HP42H Specifications

General IconGeneral
BrandMountfield
ModelHP42H
CategoryLawn Mower
LanguageEnglish

Related product manuals