EN
1.
1.1
NOTE or These give details
or further information on what has been
previously indicated and aim to prevent damage
to the machine or cause other damage.
The
The paragraphs highlighted in a square
characteristics not available on all models
documented in this manual. Check if
the characteristic is on this model.
Whenever reference is made to a position on the
machine "front", "back", "left" or "right" hand side,
2.
2.1 TRAINING
Read this manual
carefully before using the
machine. Become familiar
with the controls and the
proper use of the machine.
Failure to follow the
warnings and instructions
may result in re and/
or serious injury. Save all
warnings and instructions
for future reference.
•
INDEX
1. GENERAL INFORMATION ..................................... 1
........................................ 1
..................... 6
.. 6
............................... 6
.................. 7
........................................ 7
............................................................. 7
..................................................... 8
................................ 8
............ 8
........... 8
5. CONTROLS ............................................................ 8
5.1 Throttle control lever ....................................... 8
............................. 8
6. USING THE MACHINE ........................................... 8
6.1 Preparation ..................................................... 8
................................................. 9
.......................................................... 9
..................................................... 10
6.5 Advice for operation ..................................... 11
6.6 Stop.............................................................. 11
6.7 After use ....................................................... 11
7. MAINTENANCE .................................................... 11
7.1 General information ...................................... 11
.......................................................... 11
............ 12
.............................................. 12
7.5 Cutting means ............................................. 12
7.6 Sharpening the line cutting knife .................. 12
8. STORAGE .............................................................
8.1 Storing ..........................................................
........................................
9. HANDLING AND TRANSPORTATION ..................
10. ASSISTANCE AND REPAIRS ...............................
.....................................
12. TROUBLESHOOTING ..........................................
............................ 15
....................................................... 15
............................................. 15
To Next Page
Loading...
