9
6. DIAGNOSTIC
What to do when ...
Source of problem Corrective action
1. Petrol mower does not work
There is no oil or fuel in the
engine
Check the oil and fuel levels
not working.
Clean the spark plug and the
replace
The fuel has not been emptied
by the mower at the end of last
season
stuck. Tilt the mower over towards
the carburetor side
2. Cut grass is not blown into the grass box
The blade has received a knock Sharpen the blade or replace it.
Check the guides which direct the
grass towards the grass box
The mower’s blade housing is
dirty underneath
Clean the blade housing so as to
give an easier path for the grass
to the grass box
3. Mower struggles to cut grass
The blade is not in good
conditions
Sharpen the blade or replace it
For any doubts or problems, please do not hesitate to contact your
.
4.1 Blade maintenance
-
thorised service dealer that has the most appropriate tools.
Only blades with code shown in the table on page 2.
Given product evolution, the above mentioned blades may be replaced in
time by others, with similar interchangeable and operating safety features.
Reassemble the blade (2) with the code facing the ground, following the
steps indicated in the illustration.
.
4.2 Battery recharging (where applicable)
• Electric key ignition models
the instructions in the battery maintenance manual.
Do not connect the battery charger directly to the engine terminal. It is
not possible to ignite the engine using the battery charger as a power
source, as it may get damaged.
If you do not use the lawnmower for a long period of time, disconnect
the battery from the engine wiring, making sure the charge level is good.
• Electric push-button ignition models
Read the engine instruction manual for instructions regarding
autonomy, recharging, reinstating and maintenance of the battery.
5. ENVIRONMENTAL PROTECTION
Environmental protection should be a priority of considerable importance
environment in which we live.
– Try not to cause any disturbance to the surrounding area.
– Comply with local regulations for the disposal of waste materials after
mowing.
– Comply with local regulations for the disposal of packaging, deteriorated
parts or any elements with a strong environmental impact; this waste
must not be disposed of as normal waste, it must be separated and taken
.
– When decommissioning, do not pollute the environment with the
machine, hand it over to a disposal centre, in accordance with the local
regulations in force.
To Next Page
Loading...
Need help?
General
