movie-intercom RC4 User Manual

RC4 Wireless dimmers
Quick Start Guide
Related RC4 products
- LumenDimM2 - W-Dim3
- LumenDimM4 - W-Dim4
- LumenDim4
LightingFX Tools
phone +49 (0)30-2232 0575
fax +49 (0)30-2232 0571
web www.movie-inter.com
mail info@movie-inter.com
movie-intercom
®
Screw terminals for connection of
power supply (DC IN: 6 - 32 VDC) and 4 channels DC out (DimA, B, C, D)
3.5 mm jack for wired DMX IN/OUT (requires optional available adaptor)
Buttons and Indicators
Positive terminals (marked with "+")
are internally connected with each
other.
recommended tool for
push buttons: paper clip
V1.0-2018e © movie-intercom 2018
support@movie-inter.com
movie-intercom Blücherstr. 21 10961 Berlin, Germany
recessed buttons under oval holes > push with bent paper clip
Output indicator LEDs
channel A, B, C, D
RF status LED
linked/not linked
COP LED
> see next page
DMX data LED
steadily on when
DMX data received
Func button
Max. output/channel: 5 A continuous,
10 A non-continuous
Max. Total power handling: 16 A

movie-intercom RC4 Specifications

General

Category	Dimmer
Channels	4
DMX Channels	4
Frequency	2.4 GHz
Model	RC4
Control	Wireless DMX

Summary

RC4 Wireless Dimmers Quick Start Guide

Screw Terminals for Power and DC Output

Details screw terminals for DC power input (6-32 VDC) and 4 DC outputs (DimA, B, C, D).

Buttons and Indicators Overview

Explains DMX data LED, COP LED, output indicator LEDs, RF status LED, and the Func button.

Getting Started with RC4 Wireless Dimmers

Linking with a Transmitter

Instructions for linking the dimmer with Lumenradio or W-DMX transmitters, including unlinking.

Setup of DMX Channels and Dimmer Curves

Guides setting DMX channels and dimmer curves using a linked dimmer and console/tester.

Advanced Configuration and Control

Dimmer Bump Button Mode

Describes how Set buttons act as Dimmer Bump Buttons when no DMX data is received.

Wired DMX Control

Explains using an optional adaptor cable for wired DMX input when RF is unlinked.

Change PWM Frequency for ISL Curves

Details how to change PWM frequencies for ISL dimmer curves using the 'Set B' button.

Reset to Factory Settings

Procedure to reset the dimmer to its default factory settings using the Func and SetA buttons.

Digital Persistence and System IDs

Change Digital Persistence for LEDs

Guides on varying digital persistence for LEDs to emulate halogen bulb behavior.

Change Private System IDs

Explains how to change system IDs for multiple RC4 Magic systems in the same environment.