1
If the parts appear to be damaged or missing, contact your MovinCool dealer.
PUMP INSTALLATION
Model Name Climate Pro K36
Part No. (voltage) 484789-0240 (208/230V)
Condensate Pump Kit Installation Manual
484007-5010
WARNING
Disconnect power before installation. Beware that some residual voltage may remain in the
unit after the power is disconnected. There is a risk of electric shock.
1. Open the drain tank cover and remove the tanks from the unit.
Outlet Hose (1)
20 (6.0 m), Φ3/8 in (9.5 mm)
M4 × L10
Screw w/Washer (2)
2 (0.6 m), Φ1/2 in (12 mm)
Drain Inlet Hose (1)
Hose Clamp (1)
Condensate Pump (1)
3. Punch out the knock-o hole in the lower service panel using a tool such as a screwdriver. This
hole is used to pass through the outlet hose.
2.
Loosen the two (2) screws at boom edge and remove the other four (4) screws. Pull the lower
service panel upward and remove it from the side panel.
Loosen screws (2)
Take out screws (4)
Lower Service Panel
Knock-o Hole
To Next Page
Need help?
General
