8 9
8
7 Alarms
An alarm event will trigger the siren for a maximum of 30
seconds. If the alarm condition remains or the alarm is not
disarmed it will trigger another cycle after a pause of 5
seconds. Each alarm condition will trigger a maximum of
8 cycles.
8 Alarm trigger memory
If there has been an activation in your absence it will be
signaled by 2 long beeps on disarming, followed by a number
of high pitched ‘chirps’ to indicate the cause of the last
trigger. (See table)
9 Pairing new devices
The alarm is supplied with 2 remotes and a wireless PIR
sensor but extra sensors can be added via the LEARN button.
Press the LEARN button 5 times in a row within 5 seconds.
Each press will generate a single beep and then a nal 2
beeps will conrm the system is in pairing mode for the next
30 seconds.
Press one of the new remote buttons or trigger the sensor to
be paired. A single beep will conrm the new device is added.
To exit pairing mode press the LEARN button once.
NOTE: The alarm memory has 12 slots. Trying to save any further devices will
delete the first one.
SENTINEL ALARM & TRACKING
To Next Page
Loading...
