6 7
7
7
*Please note: Sensor exclusion is bound to a single arming cycle. Sensors
will automatically be enabled the next time the alarm is armed.
6 Tilt sensor adjustment
The TILT sensor sensitivity level is factory set to trigger
an alarm if the vehicle is tilted at an angle of approx. 1.5°
with respect to the x, y and z-axis.Sensor sensitivity can
be custom-adjusted:
(every time you enter in ‘Adjustment Mode’, the sensitivity level will
automatically be restored to the 1.5° default setting).
Disarm the alarm system.
Simultaneously press, twice in a row, remote control buttons 1 and 2:
2 ‘Bops’ will conrm the system is in ‘Adjustment Mode’
Press button 2 once to increase the tilt angle to 3.5°:
operation will be conrmed by 1 beep.
Press button 2 again to increase the tilt angle to 7°:
operation will be conrmed by 1 beep.
Press button 2 once more to increase the tilt angle to 14°:
operation will be conrmed by 1 beep.
The system will automatically exit the adjustment mode after
this step. 1 ‘BOP’ will conrm the end of the procedure.
To exit the adjustment procedure and conrm the selected tilt
angle, simultaneously press remote control buttons 1 and 2.
To Next Page
Loading...
