Warning: Please remote control the machine within the visual range. When the
ultrasonic radar or bumper sensor is turned off, the allowed remote control distance is
6m.
Blade motor control
1. Press the left and right blade-start buttons with the index fingers of your left and right
hands respectively. Then tap on the confirmation button on the screen to start the blade
motor.
2. After the blade starts normally, just keep any one of the blade-start buttons pressed to
keep the blade working.
3. Release the two blade-start buttons at the same time, and the blade will stop rotating.
Warning:
1. Please ensure that the lawn mower is in a safe condition before starting the blade to
avoid cutting stones, water pipes and other objects.
2. Please operate the machine from a safe position and keep your hands and feet away
from the operating position of the machine's blade.
3. Please keep a sufficient safe distance from bystanders, children, and pets, and be
careful of flying foreign objects that may injure people.
4. If you encounter foreign objects or any abnormality during cutting, please immediately
release the blade-start button and press the stop button.
Blade speed adjustment
1. Turn the Intelligent level switch to select the mowing mode. Turn the switch to the far
left, and when the corresponding mark is M, it is manual mode. Turn the switch to the
middle or far right, and when the corresponding mark is SMART, it is Smart mode.
2. In manual mode, the blade-speed switch is used to switch the blade speed. From left to
right, the blade speed is from slow to fast:
Left: When the switch is moved to the far left, it is a low speed gear, and the speed is
about 2600 rpm.
Medium: When the switch is moved to the middle, it is the medium speed gear, and the
speed is about 2900 rpm.
Right: When the switch is moved to the rightmost position, it is a high gear, and the
speed is about 3200 rpm.
To Next Page
Loading...