Moxa Technologies MGate MB3170I - Hardware Installation Procedure; Software Installation Information; Pin Assignments

- 4 -
Hardware Installation Procedure
STEP 1:
Use a standard straight
-through Ethernet (fiber) cable to
connect the unit to a network hub or switch.
STEP 2:
Connect your device to the unit's serial port.
STEP 3:
Mount the unit on a DIN-rail.
STEP 4:
Connect the power source to power input.
Software Installation Information
To install MGate Manager, insert the MGate Documentation and Software
CD into your PC's CD-ROM drive, and then run the following setup
program to begin the installation process from the "Software" directory:
MGM_Setup_[Version]_Build_[DateTime].exe
The filename of the latest version may have the following format:
MGM_Setup_Verx.x.x_Build_xxxxxxxx.exe.
For detailed information about MGate Manager, refer to the MGate
MB3000 User's Manual, which can be found in the "Document" directory.
Pin Assignments
Ethernet Port (RJ45)
Pin
Signal
1
Tx+
2
Tx-
3
Rx+
6
Rx-
Serial Port (DB9 Male*)
*Note: For the MB3170
series, the DB9 male
port
can only be used
for RS
-232.
Pin RS-232
RS-422/
RS-485 (4W)
RS-485 (2W)
1
DCD
TxD-
–
2
RxD
TxD+
–
3
TxD
RxD+
Data+
4
DTR
RxD-
Data-
5
GND
GND
GND
6
DSR
–
–
7
RTS
–
–
8
CTS
–
–
9
–
–
–
Serial Port (Terminal Block)
Pin
RS-422/
RS-485 (4W)
RS-485 (2W)
1
TxD+
–
2
TxD-
–
3
RxD+
Data+
4
RxD-
Data-
5
GND
GND