Need help?Do you have a question about the Moxa Technologies NPort 5130 and is the answer not in the manual?
General| Model | NPort 5130 |
|---|---|
| Category | Serial Device Server |
| Ports | 1 |
| Data Rate | 10/100 Mbps |
| Baud Rate | 50 bps to 921.6 kbps |
| Data Bits | 5, 6, 7, 8 |
| Parity | None, Even, Odd, Space, Mark |
| Stop Bits | 1, 1.5, 2 |
| Power Input | 12 to 48 VDC |
| Serial Interface | RS-232/422/485 |
| Ethernet Interface | 1 x 10/100BaseT |
| Flow Control | RTS/CTS, XON/XOFF |
| Protocols | TCP, UDP, HTTP, DHCP, DNS, ARP, ICMP |
| Connector | DB9 |
| Operating Temperature | -40 to 75 °C |
| Storage Temperature | -40 to 85 °C |
| Humidity | 5 to 95% (non-condensing) |
| Certifications | CE, FCC, UL |
Guides through initial setup, wiring, and connections.
Introduces Moxa's NPort Administrator for configuration.
Importance of keeping firmware up-to-date for security.
Restricting access to specific IP addresses.
Best practices for secure credentials.
Details the Real COM driver for transparent serial connections.
Configures the NPort to listen for incoming TCP connections.
Configures the NPort to initiate TCP connections.
Step-by-step guide for software installation.
Modifying device configurations via the utility.
Updating the device's firmware.
Steps to install drivers on a Linux host.
Configuring NPort serial ports to Linux TTY ports.
Steps to install drivers on macOS.
Configuring NPort serial ports to macOS TTY ports.
To Next Page
