Need help?Do you have a question about the Moxa Technologies NPort 5230 and is the answer not in the manual?
General| Isolation | 1.5 kV |
|---|---|
| Certification | CE, FCC, EN |
| Serial interface type | RS-232, RS-422, RS-485 |
| Serial ports quantity | 2 |
| Ethernet LAN data rates | 10, 100 Mbit/s |
| Surge protection voltage | 0.5 kV |
| Ethernet LAN (RJ-45) ports | 1 |
| Supported network protocols | ICMP, IP, TCP, UDP, DHCP, BOOTP, Telnet, DNS, HTTP, SMTP, IGMP v1/2 |
| Compatible operating systems | Windows 95/98/ME/NT/2000/XP/2003/Vista Windows XP/2003/Vista (32/64-bit) SCO Unix SCO OpenServer UnixWare 7 UnixWare 2.1, Unix SVR 4.2 Unix QNX 4.25, QNX 6 Solaris 10 FreeBSD AIX 5.x HP-UX 11i |
| Storage temperature (T-T) | -20 - 85 °C |
| Operating temperature (T-T) | 0 - 55 °C |
| Operating relative humidity (H-H) | 5 - 95 % |
| Input voltage | 12 - 48 V |
| Safety | UL, TÜV, DNV |
Weight and Dimensions| Weight | 340 g |
|---|---|
| Dimensions (WxDxH) | 67 x 100.4 x 22 mm |
Provides guidance on initial hardware setup, connections, and basic configuration steps.
Details essential wiring practices for safe and proper device installation.
Explains how to connect power to the NPort device.
Provides instructions for grounding the NPort for safety and interference reduction.
Details how to connect the NPort to an Ethernet network.
Guides on connecting serial devices to the NPort using appropriate cables.
Utilizes the Windows utility for configuring NPort device servers.
Details the steps required to install the NPort Administrator software.
Configuring basic network and system parameters for the NPort.
Setting the operational mode for each NPort serial port.
Setting baud rate, data bits, parity, and flow control for serial ports.
Maps NPort serial ports to host computer COM ports for network access.
Configuring fundamental NPort settings through the web console.
Configuring IP address, subnet mask, gateway, and DNS settings.
Configuring serial port parameters like baud rate and parity via web console.
Configuring port operation modes and related parameters via web console.
Restricting NPort access based on specific IP addresses.
Procedures for changing the NPort's administrative access password.
Configuring NPort device settings via Telnet command line interface.
Configuring NPort device settings using a serial console connection.
Highlights the importance of updating firmware for enhanced security.
Recommends disabling unused services and ports to enhance device security.
Methods to restrict product access by specifying allowed IP addresses.
Best practices for securing NPort access with strong accounts and passwords.
Maps NPort IP:Port to host COM/TTY ports for transparent serial connection.
Enables COM port control options via Telnet protocol for serial communication.
Configures NPort to act as a server, waiting for host connections.
Configures NPort to actively establish TCP connections to a specified host.
Provides faster, less reliable communication suitable for multicast applications.
Connects two NPorts to extend RS-232 distance limitations over Ethernet.
Provides step-by-step instructions for installing the NPort Administrator software.
Details procedures for unlocking password-protected NPort devices.
Explains how to access and modify NPort device settings.
Provides steps to upgrade the NPort device firmware.
Process of setting up NPort serial ports as host computer COM ports using drivers.
To Next Page
