Moxa Technologies NPort 5230 User Manual

NPort 5000 Series User Manual
141
9. macOS TTY Drivers
Basic Procedures
To map an NPort 5000 serial port to a Mac host’s tty port, follow these instructions:
1. Set up the NPort 5000. Verify the IP configuration works by using ping, telnet, etc.
2. Install the Mac driver files on the host.
3. Search or manually input the IP address of the NPort to set up virtual COM port.
Hardware Setup
Before proceeding with the software installation, make sure you have completed the hardware installation.
Please note the default IP address for the NPort 5000 is 192.168.127.254.
Installing macOS TTY Driver Files
NOTE
For the newest information, please refer to readme.txt on Mac TTY Driver. Resources location of product
information, release note, and readme file: /usr/local/share/NPortConnect
1. Obtain the driver file from Moxa’s website, at http://www.moxa.com. You may find it in the Resource
section under your product page.

Moxa Technologies NPort 5230 Specifications

General

Isolation	1.5 kV
Certification	CE, FCC, EN
Serial interface type	RS-232, RS-422, RS-485
Serial ports quantity	2
Ethernet LAN data rates	10, 100 Mbit/s
Surge protection voltage	0.5 kV
Ethernet LAN (RJ-45) ports	1
Supported network protocols	ICMP, IP, TCP, UDP, DHCP, BOOTP, Telnet, DNS, HTTP, SMTP, IGMP v1/2
Compatible operating systems	Windows 95/98/ME/NT/2000/XP/2003/Vista Windows XP/2003/Vista (32/64-bit) SCO Unix SCO OpenServer UnixWare 7 UnixWare 2.1, Unix SVR 4.2 Unix QNX 4.25, QNX 6 Solaris 10 FreeBSD AIX 5.x HP-UX 11i
Storage temperature (T-T)	-20 - 85 °C
Operating temperature (T-T)	0 - 55 °C
Operating relative humidity (H-H)	5 - 95 %
Input voltage	12 - 48 V
Safety	UL, TÜV, DNV

Weight and Dimensions

Weight	340 g
Dimensions (WxDxH)	67 x 100.4 x 22 mm