Moyer Diebel 201HTN - User Manual

Other manuals for Moyer Diebel 201HTN

Installation Manual With Service Replacement Parts68 pages

Questions and Answers

D
Dr. Kimberly Thompson DDSJul 29, 2025
Why is my Moyer Diebel Dishwasher not cleaning well?
- Z
  Zachary WashingtonJul 29, 2025
  If you're experiencing poor wash results with your Moyer Diebel Dishwasher, the water temperature might be too low; try raising the incoming water temperature. Another possibility is a defective thermostat, which may need adjustment or replacement. Also, a defective detergent injector could be the cause, requiring replacement of the injector motor. Finally, check if the wares are incorrectly loaded and reposition them or reduce the amount of wares.
A
Alexis HessAug 2, 2025
Why is water draining from my Moyer Diebel 201HTN when it's off?
- H
  hugheskevinAug 2, 2025
  If water has drained out of the wash tank of your Moyer Diebel Dishwasher while it was idle, it could be due to a few reasons. First, check if the goose-neck loop in the drain hose has been removed and re-route the drain hose if necessary. Also, ensure that the drain hose clamp is holding the drain hose in the proper position; replace or adjust the hose clamp to maintain the goose-neck.
K
Katie ThomasAug 6, 2025
How to fix a Moyer Diebel Dishwasher that will not run?
- B
  brittanyfriedmanAug 6, 2025
  If your Moyer Diebel Dishwasher won't run, there are a few things to check. First, make sure the door is completely closed. Next, verify that the main power is on by checking the breaker on the panel. Finally, ensure that the dishwasher itself is turned on.
D
Diana MillerAug 10, 2025
What to do if my Moyer Diebel Dishwasher has low or no water?
- L
  Laura MossAug 10, 2025
  If your Moyer Diebel Dishwasher has low or no water, start by checking if the main water supply is off; if so, open the supply valve. If the water supply is on, the solenoid valve may be defective, requiring a repair kit or replacement. Alternatively, the solenoid strainer could be clogged and needs cleaning. Other potential issues include a defective flow washer (replace it) or a defective timer board (test and/or replace it).
T
timothyhendersonAug 14, 2025
Why are chemicals not feeding into my Moyer Diebel Dishwasher?
- D
  David PriceAug 14, 2025
  If chemicals won't feed into your Moyer Diebel Dishwasher, the chemical supply might be low, so refill the chemical container. Another possibility is damaged or kinked supply tubing, which would need to be replaced or straightened, respectively. Also, the pick-up tube could be clogged and needs cleaning or replacement. Finally, the timer board might be defective, requiring testing or replacement.
S
samantha27Aug 19, 2025
How to increase water pressure in Moyer Diebel 201HTN Dishwasher spray arms?
- B
  Barbara HallAug 19, 2025
  If you observe low water pressure from the spray arms of your Moyer Diebel Dishwasher, the scrap screen might be clogged and needs cleaning. Alternatively, the spray arms themselves could be clogged, requiring cleaning. Another potential issue is a clogged pump intake screen; in this case, clean the sump and pump intake screen.
M
Mr. Ricky JohnsonAug 23, 2025
What to do if my Moyer Diebel 201HTN Dishwasher (HT model) stays in wash cycle?
- K
  kbakerAug 23, 2025
  If your (HT models only) Moyer Diebel Dishwasher stays in the wash cycle, it may be because the Rinse Sentry extends the wash mode for a maximum of 5 minutes to allow the final rinse water booster temperature to reach 180°F/82°C; try raising the incoming water temperature. It is also possible that the dishwasher is in Extended Wash Mode; turn Extended Wash Mode off.

Summary

Limited Warranty

Warranty of Machines

Details warranty coverage and terms for new machines.

Disclaimer of Warranties and Limitations of Liability

States Moyer Diebel's warranty limitations and disclaimers.

Installation

Electrical Connections

Procedures for connecting the dishwasher's electrical power supply.

Water Connections

Guidelines for connecting the hot water supply to the dishwasher.

Drain Connections

Instructions for properly connecting the dishwasher's drain hose.

Initial Start-up

Filling the Booster

Step-by-step guide to filling the booster heater with water.

Chemical Dispensing Pumps

Operation

Normal Wash Cycle

Step-by-step guide to running a standard wash cycle.

Troubleshooting

Service Replacement Parts

Electrical Schematics

Timer Board Troubleshooting

Timer Board Diagnostic Testing

Moyer Diebel 201HTN Specifications

General

Dimensions	820 x 598 x 550 mm
Door Type	Front opening
Dimensions (H x W x D)	820 x 598 x 550 mm
Electrical	115/60/1, 208-240/60/1, or 208-240/60/3 (field convertible)
Voltage	115/60/1, 208-240/60/1, or 208-240/60/3 (field convertible)